could someone give me a list of all the tool that a electrician use

3 Responses to “What Tools Does An Electrician Need In His Tool Kit?”

1. Harvey says:

   December 24, 2009 at 10:27 pm

   Screwdrivers:
   robertson, all sizes
   Phillips, all sizes
   One large flat (beater), and a small one.
   microscrewdrivers for finishing/thermostats, etc…
   Good linesman pliers
   side cutters
   needle nose pliers
   wire strippers
   Conduit reamer
   half round bastard file
   good tape measure
   hacksaw
   felt marker/pen/pencils
   notepad
   ticker
   flashlight
   receptical tester (gfi and normal)
   power drill
   drill bits
   driver bits (short and long)
   magnetic torpedo level
   pump pliers (also called channel locks)
   adjustable wrenches (small medium and large)
   Optional tools (maybe you don’t need them, or your employer supplies them)
   knockout punch kit
   unibit/step bit
   socket set
   torque wrench
   tri-tap threading tool
   reciprocating saw (very handy for all sorts of things)
   miners headlamp
   In addition to these I have a few others, such as an impact fastener, a thread repair tool, and a few other odds and ends. I don’t have a knockout set yet as they’re hundreds of dollars and I’m not required to at this point.
2. Danismum says:

   December 24, 2009 at 10:27 pm

   hack saw
   linesmans pliars
   side cutters
   wire strippers
   screw drivers(mainly the red robby)
   hammer
   tape measure
   and channel locks
   and torpedo level
   make sure you have these so you don’t look like an idiot on your first day
3. Earachep says:

   December 24, 2009 at 10:35 pm

   Wire strippers, multimeter, screw drivers, electrical tape, wire nuts,pliers,wallboard saw, and a uglies rule book.